Alan Gee, 1 Visual Configuration





1 Visual Schematic 


The schematic shown above is for use with a standard 1 star diagonal.  Note that only one of the supplied spacer tubes is utilized.  If you would like to use our Amici Prism Diagonal with the Alan Gee, a number of different T-2 components may be used, depending on your needs.  Please contact us for suggested arrangements.

Note: the thin plastic spacer ring is used to fully center and clamp the Alan Gee into place.  If you are using a larger SCT (Celestron 11/14 and Meade 10/12), you should mount the telecompressor and short T-adapter to the SCT reducer plate with the plate off of the telescope and held out horizontally.  This will help you to see when the spacer ring and telecompressor are properly centered and seated (if installed with the reducer on the scope and the scope horizontal, it may be possible to get the telecompressor to be mis-located and clamped off center).


last updated 3/02/02


HOME  |  Contact Us by Email (

Copyright 2007 Alpine Astronomical, LLC.  All Rights Reserved.